1 x Mach3 USB Card NVUM
1 x USB Cable
English Manual Will send by Email.1. Performance parameter
1) Support USB;
2) 12 ports photoelectric isolated input interface for ordinary digital data;
3) 10 ports photoelectric isolated output interface for ordinary digital data;
4) 1 port 0-10V spindle speed analog output interface(can change to PWM output);
5) can support 3-6 axis stepper systems,200KHz pulse output for every axis;
6) ARM motion control chip;
7) Main device is 12V-32VDC power supply input,current should higher than 0.5A;
8) Compatible with MPG input,support the digital display MPG from our company.
9) Slave funct
2.the connection of the controller includes power supply interface, USB connection interface, MPG interface, Stepper/Servo control output interface, spindle control output interface, Estop and limited switch and tool setting input interface and so on. Now we descript them in details as below.
3. Stepper motor control interface
As Figure 2-2 showed,No.1 terminal block is 6 axis stepper driver control output interface, from left to right, there are X,Y,Z,A,,B,C 6 axis output, it's common anode,the cable connection for each axis is COM+/CP-/DIR-, COM is common+ ,CP is Pulse-, DIR is direction-.Connection showed as Figure 2-3.COM+ connect with the SP+ and DIR+.
4. Spindle control output
We define the interface from left are: GND1(Output GND),VSO(0-10V adjustable speed output),INDEX(spindle speed feedback input),OUT1(common output port 1),OUT2(common output port 2),.
Take Nowforeuer inverter as the example. Spindle control output and the inverter connection showed as Figure 2-4.If ACM and DCM are closed,only need to connect one port.